Remove the disposals electrical plate and disconnect the wiring. ![]() Turn the screwdriver counter clockwise (left) to release the disposal from the mounting ring. Turn the wing nut counter-clockwise up approximately six inches and remove the installation tool by tilting the foot. Insert a screwdriver to the right of 1 of the 3 mounting lugs on the mounting ring.From below use both hands to turn the disposer counter clockwise to tighten into the lugs of the sink strainer. To do this, you will need to use a flat headed screwdriver to pry the retaining ring from the motor assembly and remove it. Once the power is off, you must remove the motor from the housing of the disposal. Spin the wing nut down to hold the disposer in position DO NOT OVERTIGHTEN. To get the snap ring on a garbage disposal, you will need to initially turn off the power to the appliance. Lift the handle again until the disposer meets the strainer.Install the snap ring and tighten the triangular flange screws firmly against the base plate. ![]() The weight of the disposer suspended from the foot will hold the sink strainer firmly in place leaving two hands free to install the parts previously placed on top of the disposer to the strainer base. Use the included wrench to turn and lock the tabs over the ridges. Spin the wing nut clockwise down into the strainer opening. Now hang the disposal by aligning the three tabs with the mounting ring. In the sink lift the tool handle raising the disposer a couple of inches. Tilt the foot of the installation tool and insert it through the sink strainer and into the opening of the disposer then pull up so that the tool’s foot is level and secure inside the disposer.Manufacturer’s supplied parts on top of the disposer in this order: snap ring, triangular flange with screws, base plate and fiber gasket. Place the garbage disposer in the cabinet directly beneath the sink strainer opening. When the disposal is secure, slip the metal flange and then the rubber washer from the drain outlet onto the drain pipe. Tighten the mounting ring by slipping a hex wrench into one of the tab slots and turn counterclockwise. Follow the manufacturer’s instructions for installing the sink strainer in the sink. Lift the disposal up to the mounting ring and turn the ring clockwise to engage the tabs.This durable wrench features 3 perfectly. How to Install a Garbage Disposer with the Plumber's Third Hand Install and remove your 3-tab locking ring garbage disposer with the DisposaLift 12 in.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |